Concrete Flatwork
Entry landings, curbs, gutters, slabs and pads for homes and businesses. We tear out broken flatwork and pour new concrete with a broom finish and control joints.
Learn More
Trinity Paving and Concrete pours concrete ADA ramps and curb ramps for business owners, churches, HOAs and landlords around Dixon. An ADA ramp is one link in the accessible route, the path from accessible parking to the entrance. We build that route in concrete: curb ramps, ramp runs, landings and the walks between them. When a ramp or walk is too steep, cracked or lifted, we tear it out and pour a new one.
ADA ramps are part of our concrete flatwork. We form each ramp to the slopes on the plan or the city's standard drawing. The building official, your designer or a CASp, a state-tested access specialist, decides whether a site complies. Call or text (707) 396-7730, and we look at the job and put the quote in writing.
Tell us about the driveway, parking lot, private road or concrete work and where it is. We look at the job and put the quote in writing.
California's 2025 building code took effect on January 1, 2026. Its Chapter 11B covers public buildings, public accommodations and commercial buildings. Under it, an ADA ramp can be no steeper than 1:12, or 8.33 percent. So every inch of rise takes at least a foot of ramp.
Side to side, the ramp can slope no more than 1:48. Ramp runs must be at least 48 inches wide, wider than the 36 inches in the federal ADA Standards. One run can climb 30 inches at most, so a full-height run at 1:12 is 30 feet long. Each run needs landings at both ends: at least 60 inches long at the top and 72 at the bottom.
Concrete can vary slightly along a run, the US Access Board notes. Its guide recommends designing outdoor ramps at 7.5 percent running slope and 1.5 percent cross slope at most. That leaves room under the code limits for small variations in the finished concrete.
California's code calls for at least one accessible route from the accessible parking to the entrance. The public sidewalk and transit stops need a route to the entrance too. A walk on that route can slope no more than 1:20, or 5 percent. Any steeper, and it counts as a ramp.
A curb ramp has the same 1:12 limit, and its flared sides can be no steeper than 1:10. The landing at its top is at least 48 inches long. Within 24 inches of the ramp, the gutter and street slope no more than 1:20. Where the ramp meets the walk, gutter or street, the surfaces must be flush.
Curb ramps carry detectable warnings: a yellow surface of truncated domes, 36 inches in the direction of travel. The ramp and its flares must stay out of drive lanes, parking stalls and access aisles. We lay out ADA stalls and their access aisles as part of our parking lot striping.
At NOAA's station near Davis, 84 percent of a normal year's rain falls from November through March. California's code says landings exposed to wet weather must be designed so water does not collect. A landing can slope no more than 1:48, about 2 percent. So we set the forms to carry rain off within that limit.
Dixon's handout on work exempt from permits includes sidewalks up to 30 inches above grade. That exemption leaves out walks that are part of an accessible route. Sidewalk and curb work in the public right-of-way takes an encroachment permit from Dixon's Engineering Department. In other towns, the city or county building office answers what your project needs, and we point you there.
Call or text for a written quote. We work about 40 miles around Dixon across Solano, Yolo and Sacramento counties.
(707) 396-7730From the first call or text to the finished work, here is how it goes.
Call or text (707) 396-7730. Tell us what needs work and the town the job is in.
We come out to see the site and the surface that is there now. We also check the slope and where the water runs.
The quote comes to you in writing before any work starts. Once you say yes, we put the job on the schedule.
On a replacement, the old asphalt is torn out and hauled off first. Then the ground is graded, and base rock goes down in compacted lifts.
The hot mix asphalt is laid and rolled, or the concrete is poured and finished. Parking lots get their striping, and the site is cleaned up.
Common questions about ada ramps around Dixon and the towns of Solano, Yolo and Sacramento counties. If yours is not here, call or text and ask.
Entry landings, curbs, gutters, slabs and pads for homes and businesses. We tear out broken flatwork and pour new concrete with a broom finish and control joints.
Learn More
We stripe new parking lots and restripe faded ones, including ADA stalls and fire lane markings. Striping is also the last step after we pave or sealcoat a lot.
Learn More
Parking lots and commercial drives for offices, apartments, churches, business parks and farm yards, built from a graded base. We pave in sections so your business stays open.
Learn MoreThe grading, the base, the asphalt or concrete and any retaining wall all come from us. One call covers the whole job.
Every surface we build starts on a graded and compacted base. That base matters here: some lots around Dixon sit on clay that cracks when dry and swells when wet. The grade is shaped so water sheds off, and thickness follows the load.
We come out and look at the job before we price it. The quote comes to you in writing, with the work spelled out.
We are based in Dixon, on Interstate 80 between Vacaville and Davis. Our work reaches Woodland, Sacramento, Elk Grove and Vallejo, and the farm country between them.
Tell us about the job and the town it is in. Call or text (707) 396-7730 or use the form, and we will get back to you.
Tell us about the driveway, parking lot, private road or concrete work and where it is. We look at the job and put the quote in writing.