Asphalt paving, sealcoating, repair and concrete around Dixon, CAAsphalt paving and concrete in Dixon, CA
Call or text (707) 396-7730 License #1162484
Trinity Paving and Concrete
Square concrete pad split into four panels by control joints, set in a gravel border in a backyard, concrete slab cost
Call (707) 396-7730 Request a Quote

How Much Does a Concrete Slab Cost in the Sacramento Valley?

A national guide updated in April 2026 puts a new concrete slab at $4 to $8 per square foot, installed. It says the average slab costs $5,400 to pour. California runs higher: the guide’s regional table lists $7.70 to $8.50 per square foot.

Another national cost guide starts the most basic slabs as low as $4 per square foot. Decorative stamped or stained slabs run up to $28 per square foot. These are market numbers, not our price list.

This guide covers flatwork poured on grade: shed pads, patio slabs, walkways, hot tub and equipment pads, and RV pads. House foundations, garage floors and other structural slabs are foundation work for another trade. Trinity Paving and Concrete pours concrete flatwork around Dixon. We look at the job and put the quote in writing.

How much does a concrete slab cost per square foot?

Here is how two national guides price a slab by the square foot, installed.

What the guide pricesInstalled cost per square foot
New slab, national (April 2026 guide)$4 to $8
New slab in California (April 2026 guide)$7.70 to $8.50
4-inch slab (the other national guide)$6 to $8
6-inch slab (the other national guide)$8 to $10
Most basic to decorative (the other national guide)$4 to $28

The April 2026 guide says coastal states, California among them, run as high as $8.50 per square foot. It also notes that thicker slabs use more concrete per square foot and more labor to pour.

How much does a concrete pad cost for a shed, a patio or an RV?

One national cost guide prices slabs by use, installed.

Slab or padSizes the guide pricesInstalled cost
Shed slab10x10 to 20x20$600 to $4,800
Patio slab10x20 to 20x20$1,000 to $6,000
RV pad200 to 700 square feet$1,200 to $8,400

The same guide puts a patio at $4 to $12 per square foot. The April 2026 guide prices a 100 square foot shed slab from as little as $600. It lists a 4-inch walkway at $6 per square foot and a sidewalk at $6 to $9. Thin walkway or sidewalk slabs can run as little as $4 per square foot, it says.

A hot tub pad or an air conditioner pad is a small slab, so the same square-foot math applies. For a hot tub, check the maker’s installation guide for the pad it calls for. Driveways carry their own ranges, covered in our concrete driveway cost guide.

What does a 10x10, 12x12 or 20x20 concrete slab cost?

Multiply the square feet by a per-square-foot range. This table uses the April 2026 guide’s California row.

Slab sizeSquare feetAt $7.70 to $8.50 per square footConcrete at 4 inches thick
10x10100$770 to $850About 1.2 cubic yards
12x12144$1,109 to $1,224About 1.8 cubic yards
20x20400$3,080 to $3,400About 4.9 cubic yards

Treat these rows as a rough guide. A thicker slab, tear-out, reinforcement or a stamped finish adds to each one.

What drives the price of a concrete slab?

Size comes first. These items move the price from there.

  • Thickness. Most slabs are 4 to 6 inches thick, one national cost guide says. Most shed slabs are about 4 inches. A concrete products maker says a driveway for cars and light trucks needs at least 4 inches. A slab for oversized loads, it says, should be 5 inches or more.
  • Base prep on clay. Capay clay covers parts of the Dixon area and the Vacaville and Fairfield valley floor. The federal soil survey says it has cracks that open and close at least once each year. Soft pockets and organic material come out before the base goes in, the products maker says. One national cost guide puts a gravel base at $1 to $3 per square foot.
  • Grading. That guide puts leveling or regrading a yard at $0.40 to $2.00 per square foot. A low spot that holds water may need grading and drainage before the pour.
  • Tear-out. Removing an old slab costs $3 to $8 per square foot, including disposal, the same guide says.
  • Reinforcement. Large slabs may need wire mesh or steel rebar, that guide says. Most shed slabs do not typically need it. The April 2026 guide adds $0.50 to $1 per square foot for rebar and $2 to $3 for fiber mesh.
  • Finish. The most basic slabs sit at the low end, and stamped or stained work reaches $28 per square foot. Our stamped concrete patio cost guide breaks down those tiers.
  • Access. One national cost guide says special equipment for pouring in hard-to-reach areas may raise labor costs. Ask how the concrete gets from the truck to the forms.

Do installers price a slab by the square foot or by the cubic yard?

Both. One national cost guide says many installers charge by the cubic yard. A cubic yard covers 81 square feet of a 4-inch slab. The April 2026 guide also prices a new slab at about $110 per cubic yard.

Thickness changes that math. At 6 inches, a cubic yard covers 54 square feet, so the slab takes half again as much concrete. A 12x12 pad takes about 1.8 cubic yards at 4 inches and about 2.7 at 6 inches.

Labor makes up 40 to 50 percent of the total, one national cost guide says. That guide puts installer labor at $3 to $5 per square foot, forms included. The April 2026 guide lists $2 to $3 per square foot for labor, covering forms, delivery and pouring.

How are control joints cut, and how long does a slab cure?

Concrete shrinks as it dries, so a slab gets control joints. They give cracks a straight, planned line to follow. The ready-mixed concrete industry’s guidance says to cut each joint at least a quarter of the slab’s thickness. Saw cuts generally go in within 4 to 12 hours, depending on weather.

Curing takes longer. A concrete products maker says to let fresh concrete cure for at least one week. A short cure can lower surface strength by up to 50 percent. Ask when the slab can carry a shed or a filled hot tub.

Do you need a permit for a concrete slab?

It depends on the slab and the address. Dixon’s Building Division prints the state building code’s list of work exempt from a building permit. Sidewalks and driveways are on it when they sit no more than 30 inches above the ground beside them. They also cannot be over a basement or part of an accessible route.

For a patio slab, a shed pad or a hot tub pad, ask the building office that covers your address. The same office answers for anything that will sit on the slab. We point you there when we look at the job.

How do you get a written quote for a concrete slab?

Published ranges are a starting point. The slab’s size, thickness, base and access set the real number. A written quote should list each of those, plus any tear-out and reinforcement.

Trinity Paving pours shed and equipment pads, walkways and concrete patios within about 40 miles of Dixon. We also pour concrete driveways. See how we pour concrete slabs and pads, or call or text (707) 396-7730.

Frequently asked questions

How much does a 12x12 concrete slab cost?
A 12x12 slab covers 144 square feet. At California's regional row of $7.70 to $8.50 per square foot, that comes to about $1,109 to $1,224. At 4 inches thick, it takes about 1.8 cubic yards of concrete.
How much does a concrete shed pad cost?
One national cost guide puts a shed slab at $600 to $4,800 installed, for a 10x10 to 20x20 slab. Another guide, updated in April 2026, prices a 100 square foot shed slab from as little as $600. Most shed slabs are about 4 inches thick and do not typically need reinforcement, the first guide says.
How thick should a concrete pad be?
Most slabs are 4 to 6 inches thick, one national cost guide says, and most shed slabs are about 4. A concrete products maker says a slab for oversized loads should be 5 inches or more. The cost guide lists $6 to $8 per square foot at 4 inches and $8 to $10 at 6.
How much concrete does a 20x20 slab take?
A 20x20 slab covers 400 square feet. At 4 inches thick, that takes about 4.9 cubic yards, since one yard covers 81 square feet. At 6 inches, a yard covers 54 square feet, so the same slab takes about 7.4 cubic yards.
Do I need a permit to pour a concrete slab?
It depends on the slab and the address. In Dixon, sidewalks and driveways no more than 30 inches above the ground beside them need no building permit. They also cannot be over a basement or part of an accessible route, the city's handout says. For a patio slab or a pad, the city or county building office answers, and we point you there.
How long does a new concrete slab need to cure?
A concrete products maker says to let fresh concrete cure for at least one week. A short cure can lower surface strength by up to 50 percent. Saw-cut control joints go in much sooner, generally within 4 to 12 hours, depending on weather.
Is this what Trinity Paving and Concrete charges?
No. Every price on this page is a market number from national cost guides, not our price list. Trinity Paving looks at the job and puts the quote in writing. Call or text (707) 396-7730.
Request a Quote

Get In Touch With Trinity Paving

Tell us about the job and the town it is in. Call or text (707) 396-7730 or use the form, and we will get back to you.

  • Call or text (707) 396-7730
  • Serving Dixon, CA and Solano, Yolo and Sacramento counties
  • Written quotes · asphalt paving, concrete and grading

Request a Quote

Tell us about the driveway, parking lot, private road or concrete work and where it is. We look at the job and put the quote in writing.

Call (707) 396-7730